Mercedes S-Class W-220
since 1998 release
Repair and operation of the car
+ Mercedes-Benz cars of the class S (W220)
+ Operation manual
- Routine maintenance
Active system of the warning of the term of approach planned THAT (ASSYST)
Schedule of routine maintenance
General information on control
Check of levels of liquids, control of leaks
Check of a condition of tires and pressure in them. Designation of tires and disks of wheels. Rotation and replacement of wheels
Replacement of motive oil and oil filter
Check of the brake system
Check of fuel system
Check of a state and replacement of hoses of a motive compartment, localization of leaks
Check of a condition of ridge belts of the streaming drive of auxiliary units
Check of functioning of the cooling system and frost resistance of cooling liquid. Liquid replacement
Check of a condition of system of production of the fulfilled gases
Check of level of oil of automatic transmission
Visual check of tightness of automatic transmission
Check of a state component of a suspension bracket and steering
Check of a condition of protective covers of power shafts
Check of level of liquid of system of hydrostrengthening of a wheel
Check of the air conditioning system
Lubricant of limiters of doors and cylinder of the lock
Visual control of a seat belt and block of a safety cushion
Check of operability of headlights and horn
Check of a state, adjustment and replacement of brushes of screen wipers
Check of a condition of the battery, care of it and charging
Replacement of an element of the filter of air of salon / coal filter of purification of air
Replacement of brake fluid
Check and replacement of spark plugs. Check of a condition of high-voltage wires
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Automatic transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Onboard electric equipment
+ Schemes of electric equipment
Replacement of brake fluidThe required special tool:
· A cap key for an otvorachivaniye of the union of removal of air.
· A transparent plastic hose with an internal diameter of 6 mm and capacity for collecting brake fluid.
· Necessary amount of the brake fluid meeting the specification.
It allows to distinguish them easily.
The remark on security measures
Brake fluid through a time of brake hoses and an air vent of the tank absorbs moisture. Thereof liquid boiling temperature in use decreases. At big load of brakes it can lead even to steam formation that reduces efficiency of action of brakes.
Brake fluid owes each 2 years, it is desirable in the spring, to be replaced with new. At the frequent movement in the mountain area, liquid needs to be replaced more often.
On HUNDRED air from the brake system, as a rule, is removed on the special device. However it can be done also without use of the specified device. At the same time the brake system is pumped over by a brake pedal. For this purpose participation of the assistant is required.
If in the course of removal of air from the brake system liquid level sharply decreases, then there is a suction of the air getting to the pump ABS. In this case removal of air needs to be made on HUNDRED with use of the special device. When replacing any brake hose air needs also to be removed from system on HUNDRED. Until it is made, it is impossible to use the car.
Sequence of removal of air:
1. The support is back right
2. The support is back left
3. The support is forward right
4. The support is forward left