Mercedes S-Class W-220

since 1998 release

Repair and operation of the car



Mercedes W220
+ Mercedes-Benz cars of the class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Automatic transmission
+ Power shafts
+ Brake system
- Suspension bracket and steering
   Security measures
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      The angles of installation of wheels of the car - the general information
      Conditions of check of angles of installation of wheels
      Adjustment of forward wheels
      Adjustment of back wheels
      Check of clearance of a body of the car
      Removal and installation of the steering mechanism
      Pump of the amplifier of steering
      Dismantling and assembly of the pump of the amplifier of steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the lower steering shaft
      Removal and installation of the drive for telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe
      Removal and installation of the blocking cylinder
      Contact spring
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment








8aff535e


Removal and installation of the blocking cylinder

Removal

 PERFORMANCE ORDER

1. Turn off a guard 36a dashboards by means of a key 020 (models without immobilizer).

2. Take the L11 coil from the blocking cylinder (model with an immobilizer).
3. Put on the plug 011 a cover 36b and turn the blocking cylinder in situation "1" by means of a key.
4. Disconnect the blocking cylinder rotation of a cover 36b counterclockwise on 90 °.


Installation

 PERFORMANCE ORDER

1. Grease an external part of the blocking cylinder 36 with sealant and insert a cover 36b.
2. Install a key through a cover 36b in the blocking cylinder 36 against the stop. The groove (shooter) on the blocking cylinder 36 has to be combined with a groove on the lock of blocking of a steering shaft (shooter).
3. Install the blocking cylinder 36 in the lock of blocking of a steering shaft.
4. Turn a cover 36b with the plug 011 clockwise on 90 ° so that it was possible to block it.
5. Turn a key in situation "0" and remove the plug 011.
6. Tighten a guard 36a on the dashboard by means of a key 020 (models without immobilizer).
7. Press the L11 coil on the blocking cylinder.